Skip to content
CremaLoop CremaLoop

Cleaning the feeder disc

The feeder disc is the rotating part that meters beans onto the burrs. Coffee oils and fines build up over time and cause stalling or “beans not feeding”, so clean it when feeding gets unreliable.

Enter Maintenance Mode (to free the disc)

Section titled “Enter Maintenance Mode (to free the disc)”

Use the speed dial to put the feeder into Maintenance Mode. This rotates the disc to a position where it lifts off easily:

Start with the dial at 0, then turn it clockwise to 9, back to 0, to 9 again and back to 0. A blinking light: Maintenance Mode is on. 0 9 dial 1 Start at 0 2 9 3 0 4 9 5 0 LED blinks: Maintenance Mode
The disc then turns clockwise and comes off by turning it anti-clockwise.

Clean it

Section titled “Clean it”
  1. Power off And disconnect the USB-C cable
  2. Remove the glass container How to
  3. Lift off the disc Anti-clockwise, after Maintenance Mode. Won't come off? Contact us, don't force it.
  4. Wipe it clean Disc, the gap to the housing and the housing top: damp cloth, mild detergent, no abrasives
  5. Dry, refit, test Refit disc and glass, power on, run a short test feed

After every use, make sure no beans are left trapped under the disc.