Skip to content
CremaLoop CremaLoop

First use

Once your feeder is installed on your grinder, here’s the first run.

  1. Charge it fully About 3 hours over USB-C, then unplug: it runs on battery. Charging
  2. Seat the glass, add beans Max 50 g, about 2 cm free at the top
  3. Press once to start The LED stays on. Press again to pause.
  4. Set the speed With the dial, see below
  5. Dial in your grind A steadier feed can shift your grind setting and dose

The speed dial

Section titled “The speed dial”
Speed dial 0 to 9. 0 to 1: the disc is still. 2 to 3: minimum feed rate. 4 to 9: variable feed rate up to the maximum at 9. Anti-stall works best from 5 up. anti-stall best 0123456789 turn clockwise to go faster 0 to 1 Disc is still 2 to 3 Minimum feed rate 4 to 9 Variable, maximum at 9 Stalls at 2 to 3? Turn to 5 or higher

The feeder disc turns counter-clockwise to dispense, and the motor automatically works through any bean stalling. After 3 minutes idle the feeder sleeps; press the power button to wake it.